4. Grasp the PCI riser-card assembly at the front grip point and rear edge; then, lift
5. If you are instructed to return the PCI riser-card assembly, follow all packaging
Installing the PCI riser-card assembly
To install a riser-card assembly, complete the following steps:
1. Reinstall any adapters and reconnect any internal cables you might have
2. Connect ServeRAID card signal cables if any.
3. Align the PCI riser-card assembly with the alignment pin and the guide rails on
to remove it from the server. Disconnect the cables. Place the PCI riser-card
assembly on a flat, static-protective surface.
instructions, and use any packaging materials for shipping that are supplied to
you.
removed in other procedures (see "Internal cable routing and connectors" on
page 136).
the chassis.
Chapter 5. Removing and replacing server components
151