Table of Contents
Advertisement
6. Slide the cable arm cover into the retention slots and install the screw to secure
7. Install the cover (see "Installing the cover" on page 146).
8. Reconnect the external cables; then, reconnect the power cords and turn on the
Removing the hot-swap backplane on the optional rear hard disk drive
cage
To remove the hot-swap backplane on the optional rear hard disk drive cage,
complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the cover (see "Removing the cover" on page 145).
4. Remove all hot-swap hard disk drives in the optional rear hard disk drive cage
5. Press the release latches and rotate out the top of the backplane ; then, lift the
186
IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
it on the side of the chassis.
peripheral devices and the server.
on page 133.
all external cables.
(see "Removing a hot-swap hard disk drive" on page 138).
backplane out of the optional rear hard disk drive cage by pulling and lifting it
up.
Advertisement
Table of Contents
