IBM x3630 M3 7377 Problem Determination And Service Manual page 136

Table 7. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, "Parts listing, Type 7377 server," on page 125 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Message
The System %1 encountered
a POST Error.
(%1 =
CIM_ComputerSystem.
ElementName)
The System %1 encountered
a POST Error.
(%1 =
CIM_ComputerSystem.
ElementName)
118
IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
Severity Description
Error A POST error has occurred.
(Sensor = Firmware Error)
Error A POST error has occurred.
(Sensor = ABR Status)
Action
1. Make sure the server meets the
minimum configuration to start
(see "Solving undetermined
problems" on page 121).
2. Update the UEFI firmware on
the primary page.
Important: Some cluster
solutions require specific code
levels or coordinated code
updates. If the device is part of
a cluster solution, verify that the
latest level of code is supported
for the cluster solution before
you update the code.
3. (Trained service technician only)
Replace the system board.
Note: Make sure the technician
refreshes the VPD.
1. Make sure the server meets the
minimum configuration to start
(see "Solving undetermined
problems" on page 121).
2. Recover the UEFI firmware
from the backup page:
a. Restart the server.
b. At the prompt, press F3 to
recover the firmware.
3. Update the UEFI firmware to
the latest level.
Important: Some cluster
solutions require specific code
levels or coordinated code
updates. If the device is part of
a cluster solution, verify that the
latest level of code is supported
for the cluster solution before
you update the code.