9. If you are instructed to return the rear hard disk drive cage, follow all packaging
Installing an optional hot-swap SAS/SATA rear 2.5-inch hard disk drive
cage
To install the optional rear hot-swap SAS/SATA hard disk drive cage, complete the
following steps:
214
IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
Hot-swap backplane
2
signal cable (I C cable)
instructions, and use any packaging materials for shipping that are supplied to
you.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 133.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
3. Remove the cover (see "Removing the cover" on page 145).
4. Loosen the screw that secure the drive filler cage to the chassis; then, rotate
the drive filler clockwise and remove the drive filler out of the bay from the
server.
LED signal cable
(from option package)