Table of Contents
Advertisement
2. Reconnect the power cord and any cables that you removed.
3. Install the PCI riser-card assembly (see "Installing the PCI riser-card assembly"
4. Install the cover (see "Installing the cover" on page 146).
5. Slide the server into the rack.
6. Turn on the peripheral devices and the server.
Removing the USB board
To remove the USB board, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the cover (see "Removing the cover" on page 145).
4. Remove the screws that secure the USB board to the chassis.
on page 151).
on page 133.
all external cables.
Chapter 5. Removing and replacing server components
179
Advertisement
Table of Contents
