Removing A Usb Hypervisor Memory Key - IBM System x3650 M4 Type 7915 Installation And User Manual

Removing a USB hypervisor memory key

To remove the USB hypervisor memory key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover (see "Removing the cover" on page 54).
4. Remove the flash device:
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 135.
Note: You must configure the server not to look for the hypervisor USB drive. See
Chapter 3, "Configuring the server," on page 141 for information about disabling
hypervisor support.
130
System x3650 M4 Type 7915: Installation and User's Guide
on page 40.
external cables (see "Turning off the server" on page 28).
USB embedded
hypervisor
flash device
a. Unlock the retention latch on the USB connector by squeezing the two
retention clips toward each other.
b. Open the retention latch.
c. Grasp the flash device and pull to remove it from the connector.
Lockbar