Installing The Cover - IBM x3630 M3 7377 Problem Determination And Service Manual

5. Loosen the two thumbscrews that secure the cover to the chassis.
6. Press on the two blue grip points and slide the cover toward the rear; then, lift
7. If you are instructed to return the cover, follow all packaging instructions, and

Installing the cover

To install the cover, complete the following steps:
1. Make sure that all internal cables are correctly routed (see "Internal cable
2. Align the cover over the server (toward the rear of the server) until the cover
3. Slide the cover forward toward the front of the server until the cover is
4. Tighten the thumbscrews on the rear of the cover to secure the cover to the
146
IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
Attention:
v Two or more people are required to remove the system from a rack cabinet.
v To completely remove the server from the rack, press the latches on the
sides on the slide rails.
the cover off the server. Set the cover aside.
Attention: For proper cooling and airflow, replace the cover before you turn
on the server. Operating the server for extended periods of time (over 30
minutes) with the cover removed might damage server components.
use any packaging materials for shipping that are supplied to you.
routing and connectors" on page 136).
edges slip into position over the chassis.
Attention: Before sliding the cover forward, make sure that all the tabs on
both the front, rear, and side of the cover engage the chassis correctly. If all the
tabs do not engage the chassis correctly, it will be hard to remove the cover
later.
completely closed.
chassis.
Half-out latch