Removing The 2.5-Inch Hs Hdd Backplane - IBM x3630 M3 7377 Problem Determination And Service Manual

10. Install the hot-swap hard disk drives (see "Installing a hot-swap hard disk
11. Reconnect the external cables; then, reconnect the power cords and turn on

Removing the 2.5-inch HS HDD backplane

To remove the hot-swap hard disk drive backplane, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove all hot-swap hard disk drives (see "Removing a hot-swap hard disk
4. Remove the cover (see "Removing the cover" on page 145).
5. Rotate the blue latches clockwise till they are in horizontal positions.
6. Press the release latches and rotate out the top of the backplane; then, remove
7. Replace the system fan cage (see "Installing the system fan cage" on page
191).
8. Reconnect the power cable, then the signal cables.
9. Install the cover (see "Installing the cover" on page 146).
drive" on page 138).
the peripheral devices and the server.
on page 133.
all external cables.
drive" on page 138).
Lock point
the backplane out of the server by pulling and lifting it up.
Latche
Chapter 5. Removing and replacing server components
199