IBM x3630 M3 7377 Problem Determination And Service Manual page 162

v After you replace the battery, you must reconfigure the server and reset the
v To avoid possible danger, read and follow the following safety statement.
v To order replacement batteries, call 1-800-IBM-SERV within the United States,
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
See the IBM Environmental Notices and User's Guide on the IBM Documentation
CD for more information.
To install the replacement battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
2. Tilt the battery so that you can insert it into the socket on the side opposite the
3. Press the battery down into the socket until it clicks into place. Make sure that
4. Install the PCI riser-card assembly (see "Installing the PCI riser-card assembly"
5. Install the cover (see "Installing the cover" on page 146).
6. Reconnect the external cables; then, reconnect the power cords and turn on the
144
IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
system date and time.
and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your support center or business partner.
replacement battery.
battery clip.
the battery clip holds the battery securely.
on page 151).
peripheral devices and the server.