Removing A Usb Flash Key - IBM BladeCenter HS22V 7871 Problem Determination And Service Manual

Removing a USB Flash key

Use this information to remove a USB Flash key from the blade server.
The following illustration shows the removal of a USB Flash key from the blade
server.
To remove the USB Flash key, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on page
4. If an optional expansion unit is installed, remove the expansion unit (see
5. If an optional CIOv expansion card is installed, remove the CIOv expansion
6. Locate the USB Flash key on the system board (see "Blade server connectors"
7. Using your fingers, push the USB Flash key out of the connector. It is
8. If you are instructed to return the USB Flash key, follow all packaging
70
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide
page 49.
the blade server from the BladeCenter unit" on page 52).
55).
"Removing an optional expansion unit" on page 57).
card (see "Removing a CIOv-form-factor expansion card" on page 74).
on page 14).
recommended to use your finger to push the shoulder of the USB Flash key
away from the connector.
instructions, and use any packaging materials for shipping that are supplied to
you.