BELL HELICOPTER 430 Maintenance Manual page 94

BHT-430-MM-2
5-24. PROGRESSIVE INSPECTION — EVENT 9 (CONT)
DATA REFERENCE
Chapter 67
Chapter 96
Chapter 52
Chapter 95
Chapter 52
Chapter 25
Chapter 25
Chapter 25
Chapter 25
Chapter 26
Chapter 11 and
BHT-430-FM-1
5-00-00
Page 64 Rev. 15 26 JAN 2007
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
3. Measure the amount of minimum friction on the cyclic stick,
collective stick and the tail rotor pedals. Adjust the minimum
friction as necessary. (F2)
4. Examine the condition of the electrical and avionics
components in the nose compartment. Make sure they are
correctly installed. Examine the electrical harnesses and cables
for frayed wires and loose or broken clamps and fasteners.
5. Examine the nose compartment door for damage. Make
sure it latches correctly. (F1/F2)
6. Examine the pitot tubes. Make sure they are correctly
attached. (F1/F2)
7. Examine the crew doors, passenger doors and baggage
compartment doors for damage or corrosion. Examine the
positive locking mechanisms. Examine the door seals for tears
or separations. Make sure the doors are correctly attached to
the airframe structure. (F1/F2/F3/F4)
8. Examine the seat cushions and seat backs for tears and
deterioration. Make sure they are correctly attached. (F1/F2/F3/
F4)
9. Examine the seat assemblies to make sure they are
correctly attached to airframe structure. (F1/F2/F3/F4)
10. Examine the crew seat attenuation indicators. (F1/F2)
11. Examine the safety belts and shoulder harnesses for
deterioration. Make sure they are correctly attached to the
airframe structure. (F1/F2/F3/F4)
12. Examine the cabin fire extinguisher for damage or
corrosion. Examine the operation of the quick opening clamp.
Make sure the fire extinguisher is fully charged. (F1/F2)
13. Examine the placards and instrument panel decals. Make
sure they are clear and legible. (F1/F2)
INITIAL
MECH OTHER