BELL HELICOPTER 430 Maintenance Manual page 112

BHT-430-MM-2
5-29. EVERY 300 HOURS OF COMPONENT OPERATION (CONT)
DATA REFERENCE
Chapter 62
BHT-430-CR&O-2
Chapter 62
5-00-00
Page 82 Rev. 15 26 JAN 2007
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
Examine the duplex bearing before you lubricate the
swashplate.
f. Rotate the swashplate outer ring and make sure the
duplex bearing operates smoothly. Replace the bearing if it feels
rough.
g. Measure the
necessary.
This inspection does not apply to 430-010-400-103
swashplate configuration with single piece bearing
sets and non-splitted ball sleeve guide bearings.
h. Examine the area around the upper and lower ball
sleeve bearing sets for signs of fretting /rotation.
i. Install the pitch change links and connect the drive link
to the rotating ring.
NOTE
swashplate friction and
NOTE
INITIAL
MECH OTHER
adjust if