Progressive Inspection — Event 11 - BELL HELICOPTER 430 Maintenance Manual

5-26. PROGRESSIVE INSPECTION — EVENT 11
DATA REFERENCE
Paragraph 5-13
Chapter 67 and
BHT-ALL-SPM
Chapter 71
Chapter 63
Chapter 63 and
BHT-430-CR&O-2
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
DATE: __________________W.O. _____________________
FACILITY: _________________ _ ________________________
HELICOPTER S/N: __________ _ ________________________
REGISTRY NO.: ____________ _ ________________________
TOTAL TIME:_______________________________________
SIGNATURE:_______________ _ ________________________
GENERAL:
1. Do a complete 50 hour inspection.
DETAIL:
1. Open the access panels in the tunnel behind the pilot
station. Examine the lower and upper cyclic and collective pitch
control bellcranks for loose bearings, corrosion or mechanical
damage to the clevises. Make sure they are correctly attached
to the supports and control tube bearings. (F5/F6)
2. Examine the engine control cables and idle stop solenoids
for corrosion and damage. Make sure they are correctly
attached. (F5/F6)
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
3. Examine the left and right pylon fluid mounts for corrosion,
damage and correct fluid level. Make sure they are correctly
attached. (F5/F6)
4. Examine the upper and lower lift link rod end bearings for
serviceability. (F5/F6)
NOTE
26 JAN 2007 Rev. 15
BHT-430-MM-2
INITIAL
MECH OTHER
5-00-00
Page 71