Every 100 Hours Of Component Operation; Swashplate Controls; Main Rotor Yokes - BELL HELICOPTER 430 Maintenance Manual

5-28.

EVERY 100 HOURS OF COMPONENT OPERATION

DATA REFERENCE
Chapter 62
Chapter 12
Chapter 4
ECCN EAR99
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
DATE: __________________W.O. _____________________
FACILITY: _________________ _ ________________________
HELICOPTER S/N: __________ _ ________________________
REGISTRY NO.: ____________ _ ________________________
TOTAL TIME:_______________________________________
SIGNATURE:_______________ _ ________________________

SWASHPLATE CONTROLS

1. Examine the swashplate assembly.
a. Remove the pitch change links and disconnect the drive
link from the rotating ring. (R1)
Examine the duplex bearing before you lubricate the
swashplate.
b. Rotate the swashplate outer ring and make sure the
duplex bearing operates smoothly. Replace the bearing if it feels
rough.
c. Lubricate swashplate duplex bearing.

MAIN ROTOR YOKES

Step 1 is an airworthiness inspection limitation. This
inspection only applies to main rotor yokes with
cracks greater than 3.0 inches (76.19 mm) located
between station 23.0 and station 31.0.
NOTE
NOTE
1 NOV 2012 Rev. 19
BHT-430-MM-2
INITIAL
MECH OTHER
5-00-00
Page 79