Inspection Limitations Schedule - BELL HELICOPTER 430 Maintenance Manual

BHT-430-MM-2
COMPONENT
Main Rotor Yoke Assembly
Main Rotor Yoke Assembly
Main Rotor Yoke Assembly
Pylon Fluid Mount
Main Rotor Yoke Assembly
Main Rotor Blade Assembly
Pylon Fluid Mount
NOTES:
Inspection limitation for the part number listed applies to all successive dash numbers for that component,
1
unless otherwise specified.
Refer to Chapter 5 for inspection check sheets.
2
Inspection applies to yokes with cracks greater than 3.0 inches (76.19 mm). Inspection is limited to arm
3
which has crack(s) greater than 3.0 inches (76.19 mm). Refer to
Refer to Figure 4-2
4
Inspection applies to yokes with cracks less than 3.0 inches (76.19 mm). Inspection is limited to arm that
5
has crack(s) less than 3.0 inches (76.19 mm). Refer to
6 Refer to Figure 4-3
This inspection does not apply to pylon fluid mount 430-310-200-107.
7
8 Refer to Figure 4-4
9 Refer to Figure 4-5
10 Refer to Figure 4-6
4-00-00
Page 10 Rev. 19 1 NOV 2012
Table 4-2. Inspection Limitations Schedule
PART NUMBER
430-010-101-101
430-010-101-101
430-010-101-101
430-310-200-103/-105
430-010-101-101
430-015-001-101
430-310-200-107
for inspection details.
for inspection details.
for inspection details.
for inspection details.
for inspection details.
INSPECTION INTERVAL
1
(HOURS OPERATION TIME)
6
10
Figure 4-1.
Figure 4-1.
TC APPROVED
2
100 hours
3
150 hours
4
600 hours
5
600 hours
7
2500 hours
8
2500 hours
9
2500 hours
ECCN EAR99