Crash Damage; Types Of Inspections - BELL HELICOPTER 430 Maintenance Manual

BHT-430-MM-2
3. Make sure that the scheduled inspections, the
special inspections, and the required tests for all of the
installed kits are complied with.
4. Make sure all parts and components for which
Historical Service Records
documented traceability to their original installation in
the helicopter.
5. Make sure that all limited life parts that have
completed their published
replaced.
6. Make sure that all of the components that have
completed their published overhaul periods are
overhauled.
7. Make sure that all of the maintenance that is
done on the helicopter is done by an approved
maintenance organization.
The maintenance organization/person doing the
maintenance is responsible for the quality of the
maintenance done.
The owner/operator
maintenance organization/person
maintenance to perform the tasks listed by prior
arrangement through a separate formal agreement.
5-3.

CRASH DAMAGE

Because of the many possible combinations that can
result from crash damage, it is not possible to include
the specified repair schemes in this category. The
helicopter mechanic must make an analysis of the
crash damage for each situation. Do the repairs in
accordance with the degree of damage to the specific
part and the applicable repair instructions in this
manual. Call Bell Helicopter Textron Product Support
Engineering with your analysis of the crash damage.
5-4.

TYPES OF INSPECTIONS

1. The maintenance
scheduled inspections, special inspections, conditional
inspections, component interim inspections, and
component overhaul inspections.
a. Scheduled inspections must occur at specified
operating intervals. The intervals may be in operating
time (hours), cycles, torque events (R.I.N.), calendar
5-00-00
Page 4 Rev. 18 9 SEP 2011
are required
operating limits
may choose to ask
doing
procedures may include
(days, months, years) or other assigned units. This
makes sure that the helicopter is airworthy.
b. Special inspections are of a temporary nature
or of a special interval not consistent with the
scheduled inspections.
have
c. Conditional inspections do not occur at a
specified time. They are based on known or suspected
unusual events, known or suspected malfunctions or
defects.
are
d. An
overhauls.
e. The component overhaul schedule gives the
elapsed operating time at which a component must be
removed, disassembled, examined for condition, and
overhauled in accordance with data approved by Bell
Helicopter Textron.
2. Lubrication and service requirements are in
addition to those stated in this chapter (Chapter 12).
3. For corrosion control, refer to the Corrosion
Control Guide
the
BHT-ALL-SPM.
the
4. For the
Rolls-Royce Operations and Maintenance Manual for
the scheduled
conditional inspection, and component overhaul
schedule.
5. For the common Bell Helicopter Textron approved
optional equipment that is integrated into this
maintenance manual, refer to this chapter for the
scheduled
component
overhaul inspection.
6. For all other Bell Helicopter Textron approved
equipment, refer to the applicable Supplement in
Chapter 99 of this manual for the scheduled
inspection, special inspection, conditional inspection,
component
overhaul inspection.
7. For the inspection requirement for optional
equipment approved
Approval/Certificate (STA/STC), refer to the applicable
STA/STC documentation. Maintenance and inspection
interim inspection occurs
(CSSD-PSE-87-001)
250-C40B engine,
inspection, special
inspection, conditional
interim inspection, and
interim inspection, and
under Supplement
between
and the
refer to the
inspection,
inspection,
component
component
Type
ECCN EAR99