BELL HELICOPTER 430 Maintenance Manual page 102

BHT-430-MM-2
5-26. PROGRESSIVE INSPECTION — EVENT 11 (CONT)
DATA REFERENCE
Chapter 63
Chapter 63
Chapter 63
Chapter 63
Chapter 63
Chapter 65 and
BHT-430-CR&O-3
Chapter 63
Chapter 12 and
Chapter 79
5-00-00
Page 72 Rev. 15 26 JAN 2007
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
5. Examine the transmission for correct fluid level and leaks.
(F5/F6)
6. Remove the transmission chip detectors. Clean and
examine the chip detectors. Install the chip detectors. (F5/F6)
7. Examine the left longitudinal restraint spring and support
for damage. Make sure they are correctly attached. (F5)
8. Examine the right longitudinal restraint spring and the
lateral restraint spring and support for damage. Make sure they
are correctly attached. (F6)
9. Examine the rotor brake system for leaks. Examine the
level and color of the fluid in the reservoir. Replace the brake
linings if they are worn more than the acceptable limits. Make
sure the brake linings are correctly attached. Examine the brake
disc for damage. (F3/F4/F5/F6)
10. Examine the tail rotor driveshaft coupling over-temperature
indicators for discoloration. Examine the driveshaft coupling and
surrounding area for slung grease. (R1)
11. Examine the main driveshaft over-temperature indicators
on the transmission and engine end driveshaft couplings for
discoloration. Examine the driveshaft couplings and surrounding
area for slung grease. (R1)
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
12. Examine the left and right engine oil tanks for correct fluid
level and leaks. Examine all oil lines for leaks. (F5/F6)
NOTE
NOTE
INITIAL
MECH OTHER