BELL HELICOPTER 430 Maintenance Manual page 104

BHT-430-MM-2
5-26. PROGRESSIVE INSPECTION — EVENT 11 (CONT)
DATA REFERENCE
Chapter 67 and
BHT-ALL-SPM
Chapter 29
BHT-430-CR&O-2
Chapter 53
5-00-00
Page 74 Rev. 15 26 JAN 2007
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
19. Examine the cyclic and collective shaft assemblies and
control tubes installed on the roof for loose bearings, wear,
corrosion or mechanical damage. Make sure they are correctly
attached. (F5/F6)
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter to service.
20. Examine the hydraulic lines for leaks. Examine the color
and level of the fluid in the PC-1 system and PC-2 system
reservoirs. Examine the module pressure and return filters for
impending bypass indication. Make sure that the flexible hoses
are in good condition and do not show signs of chafing. (F5/F6)
21. Inspect hydraulic actuator support attaching nuts for proper
torque. (R1)
22. Remove the fairing cover plate(s) and examine the wing(s)
to fuselage attachment points for corrosion, looseness and
damage. Check torque of attaching bolts/nuts.
NOTE
INITIAL
MECH OTHER