BELL HELICOPTER 430 Maintenance Manual page 47

5-14. 150 HOUR INSPECTION (CONT)
DATA REFERENCE
Chapter 12 and
Chapter 79
Chapter 63
Chapter 63 and
BHT-430-CR&O-2
Chapter 63
Chapter 63
Chapter 71
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
25. Examine the left and right engine oil tanks for correct fluid
level and leaks. Examine all oil lines for leaks. (F5/F6)
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
26. Examine the left and right pylon fluid mount assemblies for
corrosion, damage and correct fluid level indication. Make sure
they are correctly attached. (F5/F6)
27. Examine the upper and lower lift link rod end bearings for
serviceability. (F5/F6)
28. Examine the left longitudinal restraint spring and support
for damage. Make sure they are correctly attached. (F5)
29. Examine the right longitudinal restraint spring and the
lateral restraint spring and support for damage. Make sure they
are correctly attached. (F6)
THE INGESTION OF BROKEN INLET SCREEN
SEGMENTS CAN CAUSE FOREIGN OBJECT
D A M A G E TO T H E E N G I N E C O M P R E S S O R
SECTION.
30. If installed, examine both of the engine inlet screens for
damage. (F5/F6)
NOTE
NOTE
CAUTION
26 JAN 2007 Rev. 15
BHT-430-MM-2
INITIAL
MECH OTHER
5-00-00
Page 17