Position And Secure The Cable - Teledyne TIENet 360 LaserFlow Ex Installation And Operation Manual

TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 2 Preparation and Installation
Figure 2-11 Position and secure the cable
2-12
7. Tighten the cord grip sealing nut (Figure 2-11).
If using conduit instead of the cord-grip fitting, the conduit must
be sealed to prevent harmful gases and moisture from entering
the Signature enclosure. Failure to seal the conduit may
reduce equipment life.
8. Close the front panel and fasten with the two Phillips
screws.
CAUTION