Table of Contents
Advertisement
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 4 Setup with 2160 LaserFlow Module
Figure 4-4 Drop down list of measurements for 2160 Module
4-4
To select and configure any parameter for your connected
devices, click the "Jump to measurement tab" button at the
top of the Site window and hover over the 2160 LaserFlow
Module. Explanations for the listed measurements are provided
in Figure 4-4.
360 Distance
Distance between the bottom of the sen-
sor and the surface of the flow stream.
360 Level
Level of the flow stream surface
360 Velocity
Average velocity of the flow stream
360 Case Temperature
Internal temperature of the LaserFlow Ex
sensor housing
360 Laser Temperature
Temperature of the laser assembly
360 X-Axis
Tilt about the 'x' axis (roll)
360 Y-Axis
Tilt about the 'y' axis (pitch)
Click on any parameter on the Measurements tab or in the Jump
to Measurements tab list to open a dedicated tab to view details
or set up data storage.
To prevent a parameter from being displayed on the Measure-
ments tab, select the Hide in Measurements box.
The settings for level and velocity input are defined on their
respective tabs in Flowlink. To save any changes made to the set-
tings, click the "Apply" button.
360 Laser Diode Current
Current draw of the laser diode
360 Ultrasonic Signal
Strength of the ultrasonic return echo
Sense Voltage
Measurement of window clarity (under
100 mV)
360 Air Temperature
Temperature of surrounding (ambient)
air
360 Doppler Power
Strength of the laser return Doppler
signal
360 Window Temp
Temperature of the window
360 Input Voltage
TIENet voltage measured by the
LaserFlow sensor
Advertisement
Table of Contents
