Table of Contents
Advertisement
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 5 Maintenance and Optional Kits
5.4.2 Replacing the Nose
Piece
Figure 5-2 Location and orientation of cross-pins for mounting block installation
5-4
1. Fasten the sensor back together by cross-tightening the 6
large Phillips screws in diagonal order until the two sec-
tions are flush against each other.
When reinstalling all self-tapping screws, avoid stripping the
plastic threads. First seat each screw in its hole and, with light
downward pressure, rotate the screw counter-clockwise until it
falls into its thread groove with a "click". Then tighten the
screw.
2. If applicable, reinstall the mounting block, ensuring that
both flat and split washers are included.
Side cross-pin
(1 of 2)
Center cross-pin
CAUTION
Advertisement
Table of Contents
