Table of Contents
Advertisement
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 2 Preparation and Installation
2.5 Sensor Installation
Tools and
Requirements
2.5.1 Tools Required
2.5.2 Sensor and Mounting
Equipment
Dimensions
Figure 2-14 Overall dimensions including wall mounting hardware (part 1)
2-14
The Signature flowmeter or 2160 LaserFlow Module does not
have to be mounted near the flow stream. The flowmeter can be
installed at a convenient, protected location and the sensor cable
can be routed through user-provided conduit back to the flow-
meter.
Proper installation of the LaserFlow Ex is critical for accurate
measurement.
See Appendix B.2 Equipment and Recommended Tools.
Complete mounting assembly dimensions are provided in
Figures 2-14 through .
Refer to the appropriate drawing(s) when planning the instal-
lation and adjusting the mounting hardware.
Advertisement
Table of Contents
