Tienet Device Terminal Strips - Teledyne TIENet 360 LaserFlow Ex Installation And Operation Manual

Figure 2-6 TIENet Device terminal strips
Lock Nut
(concave side
facing wall)
Figure 2-7 Installing cable with a cord-grip fitting
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Before proceeding, ensure that the flowmeter has been
disconnected from mains power.
Note
The following steps include instructions for installing cord-grip
fittings. Some applications may use user-supplied
duit for cable routing.
1. Remove one of the 6-position plug-in terminal strip connec-
tors from the case board.
2. If using a cord-grip fitting, install the cable nut in the
appropriate opening on the bottom of the Signature enclo-
sure, securing it to the wall with the lock nut (concave side
facing wall).
Seal
Cable Nut
(color may vary)
Section 2 Preparation and Installation
WARNING
Sealing Nut
3
/ " ID con-
4
2-9