2.4.3 Remote Ultrasonic
Cable Connection:
310 Ultrasonic Sensor
Figure 2-12 Preparing the LaserFlow Ex connector receptacle
Figure 2-13 Secure caps and connect 310 ultrasonic plug to
LaserFlow Ex
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
1. Prepare the LaserFlow Ex connector receptacle by remov-
ing the cap (press down on the spring clip and pull out the
cap).
2. Remove the stainless steel cap from the 310 ultrasonic
plug and push the protective caps from the LaserFlow Ex
module and ultrasonic together.
3. Aligning the pins on the 310 ultrasonic plug with those in
the connector receptacle, push the ultrasonic plug into the
receptacle until the spring release "clicks".
To be certain that the connectors are locked, lightly pull on the
cable connector; the cable should be held in place by the spring
release clip.
Section 2 Preparation and Installation
2-13