Table of Contents
Advertisement
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 1 Introduction
1.6 Unpacking
Instructions
1.6.1 Protective Window Cap
Figure 1-2 Remove protective window cap before installation
1-6
When the system arrives, inspect the outside packing for any
damage. Then carefully inspect the contents for damage. If there
is damage, contact the delivery company and Teledyne ISCO (or
its agent) immediately.
If there is any evidence that any items may have been
damaged in shipping, do not attempt to install the unit.
Please contact Teledyne ISCO (or its agent) for assistance.
When you unpack the system, check the items against the
packing list. If any parts are missing, contact the delivery
company and Teledyne ISCO's Customer Service Department.
When you report missing part(s), please indicate them by part
number. In addition to the main packing list, there may be other
packing lists for various sub-components.
It is recommended that you retain the shipping cartons as they
can be used to ship the unit in the event that it is necessary to
transport the system. Please complete the registration card and
return it to Teledyne ISCO.
Leave the protective window cap in place until the sensor is
ready to be installed.
Before installation, remove the cap. The sensor will not be able to
measure velocity with the cap in place. Retain the cap for use
during cleaning, storage, or shipment, to protect the laser
window from damage.
Be sure the protective window cap is installed during cleaning,
storage, or shipment.
WARNING
CAUTION
Advertisement
Table of Contents
