Table of Contents
Advertisement
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 2 Preparation and Installation
4. Push the sensor carrier
clamp onto the tube coupler
until the coupler appears on
the other side of the clamp.
Align the carrier with both
arms parallel to the flow sur-
face and cross-tighten the
bolts so the carrier is held
firmly in position. Ensure
the alignment tabs are fac-
ing up (see Figure 2-19).
Note that some realignment
will be necessary following
installation of the LaserFlow
Ex sensor; ensure that all
hardware is tightened fol-
lowing final alignment.
Figure 2-19 Wall Mount: Sensor carrier installed on tube coupler
2-20
End of Tube
Coupler
Note
After initial installation and sensor alignment, the remaining
steps are often possible to perform from above ground, with
the optional sensor retrieval arm.
If lowering the LaserFlow Ex from above ground, ensure
that it does not become dislodged while being lowered,
possibly endangering any personnel who may still be below
ground.
Alignment
Tabs
Sensor Carrier
Clamp
WARNING
Advertisement
Table of Contents
