TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 4 Setup with 2160 LaserFlow Module
4.2.2 360 Velocity
The 360 Velocity measurement tab has a grid containing 3 pos-
sible measurement points. The measurement points are acti-
vated and deactivated by selecting or deselecting the appropriate
check box. To save the measurement settings, click the "Apply"
button (F9).
As the LaserFlow Ex begins to take readings, the grid becomes
populated with a velocity reading and time stamp for each active
measurement point (points where a valid reading could not be
obtained will display the word "invalid").
Prior to operation, the LaserFlow Ex sensor must be set up for
measurement using the 360 Velocity grid. Refer to Section 4.3
Sensor Positioning and Adjustment
Figure 4-7 360 Velocity Measurement tab in Flowlink
4-7