Appendix C Velocity Error Codes; Introduction; Importing Data Dump (.Ddp) Files (Signature Only - Teledyne TIENet 360 LaserFlow Ex Installation And Operation Manual

TIENet™ 360 LaserFlow Ex™
Velocity Sensor

Appendix C Velocity Error Codes

C.1 Introduction
C.2 Importing Data Dump
(.ddp) Files
(Signature Only)
Erroneous flow data can result from a number of factors. The
LaserFlow Ex system provides numbered error codes associated
with the 360 Velocity data to assist in troubleshooting.
If using the 2160 LaserFlow Ex module, error codes are viewable
using Teledyne ISCO Flowlink® software. If using the Signature
flowmeter, error codes are viewable in the bottom panel of the
display. Definitions of the error codes are provided in Table C-1.
For further assistance, contact the factory.
Flow data can be downloaded from the Signature flowmeter onto
a USB flash drive in the form of a .ddp (Data Dump) file.
To download the data:
1. Connect a flash drive to the USB port on the front panel of
the Signature flowmeter. From the USB Options menu,
select Retrieve Data.
2. Select "All data" or specify a start date or date range, and
press NEXT. The data will be stored on the connected flash
drive in the "ISCO" folder.
3. Connect the flash drive to a computer with Flowlink
installed.
4. Launch the Flowlink application.
5. Copy the file using one of the methods below:
a. Select File > Import. When the import window appears,
browse to the folder containing the desired .ddp file.
Select the file and click Open.
b. Select "Signature Data Transfer" from the File menu
and then browse to the appropriate folder.
C-1