IBM B01 Service Manual page 72

IOSP
'Chapter 6. Single Board Computer and Attached 1/0
Start of Repair for 1/0 and Service Processor (IOSP)
Problem Area Reported Reference Section
I/O and Service Processor (Single Soard "Description and Layout of the Single Soard
Computer) Information Computer (SSC)"
1/0 and Service Processor (Single Soard "Single Soard Computer Diagnostics" on page 69
Computer) Diagnostics
SSC Attached 1/0 Information and Diagnostics "Resolving Keyboard, Monitor, and Mouse
Problems" on page 71
"Diskette Drive" on page 70
"SSC SCSI Interface" on page 46
"4MM DAT Tape" on page 48
"CD-ROM" on page 48
Chapter 4, "PCI/ISA SUS and Adapters" on
page 13
Chapter 7, "SSA RAID Adapter, SSA, and RAID"
on page 73
SEEPS during Power-On Self Test (POST)
"BIOS Beep Codes" on page 64
Configuration Jumpers "Configuration Jumpers" on page 54
BIOS Operations "BIOS Operation" on page 55
OS/2 Trap Error 0000-0010 Go To Application Software error and contact the
next Support Level
SSC and Attached 1/0 Removal and Chapter 8, "Removal and Replacement
Replacement procedures Procedures" on page 141
Description and Layout of the Single Board Computer (SBC)
© Copyright IBM Corp. 1999
The SBC is based on an Intel Pentium processor. The SBC has PCI, ISA,
Ethernet, display, keyboard, mouse, and other standard interfaces. The SBe is the
engine part of the 10SP that performs 1/0 emulation for all communications and
storage operations.
The 10SP can interface with a customer LAN to facilitate system management
functions via LAN adapter, and can interface with a customers analog phone line to
facilitate remote service operations via a serial port attached modem. A display,
keyboard and mouse are also attached.
A layout of the sse Card follows:
51