Transport And Storage; Inspection; Transport - ABB ProcessMaster FEM630 Operating Instructions Manual

12
F EM63 0 | E L EC TR OM AG N E T I C FLOWM E T E R | O I/F E M6 3 0-EN RE V. A
4

Transport and storage

Inspection

Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.

Transport

DANGER
Life-threatening danger due to suspended loads .
In the case of suspended loads, a danger of the load falling
exists.
• Standing under suspended loads is prohibited.
WARNING
Risk of injury due to device slipping .
The device's center of gravity may be higher than the
harness suspension points.
• Make sure that the device does not slip or turn during
transport.
• Support the device laterally during transport.
NOTICE
Potential damage to the device!
The protection plates or protection caps mounted at the
process connections on devices with PTFE / PFA liners
may only be removed immediately before installation.
• To prevent possible leakage, make sure that the liner
on the flange is not cut or damaged.
Figure 6 Transport instructions - ≤ 18" (DN 450)
Flange devices ≤ 18" (DN 450)
• Use carrying straps to transport flange designs smaller
than 18" (DN 450).
• Wrap the carrying straps around both process
connections when lifting the device.
• Chains should not be used, since these may damage the
housing.
G12034