ABB ProcessMaster FEM630 Operating Instructions Manual page 100

100
F EM63 0 | E L EC TR OM AG N E T I C FLOWM E T E R | O I/F E M6 3 0-EN RE V. A
8 . . .Operation
. . .Parameter descriptions
Menu / parameter
Diagnostics / . . .Diagnosis Control / . . .Noise Check
Start Noise Check
Result Noise Check
Power Spectrum
Amplitude 1 Value
Amplitude 2 Value
Amplitude 3 Value
Amplitude 4 Value
Frequency 1
Frequency 2
Frequency 3
Frequency 4
Diagnostics / . . .Diagnosis Control / . . .Fingerprints
Tx Factory CMR
Tx Factory 1m/s
Tx Factory 10m/s
Se Factory Coil Ind.
Se Factory Imp. E1
Se Factory Imp.E2
Start. FP verification
Result FP verification
Tx Customer CMR
Tx Customer 1m/s
Tx Customer 10m/s
Se Customer Coil Ind
Se Customer Imp. E1
Se Customer Imp. E2
Description
Start the 'Noise Check' function, using
The LCD display displays the results of the Noise Check.
Current power spectrum.
Display the four highest amplitudes in the power spectrum.
Display the four highest amplitudes in the frequency corresponding to the power spectrum.
The 'fingerprint database' allows for a comparison of the values at the time of factory calibration with the
currently recorded values. Errors in the integrity of the device can already be detected early on. Corrective
measures can be taken.
Here: Display of the determined values at the time of the factory calibration.
Create a fingerprint and perform verification.
Display of the verification result. Based on the result, one of the following messages will be issued.
'FP Verificat. passed', 'CMR failed', '1m/s failed', 'CMR, 1m/s failed'10m/s failed', 'CMR, 10m/s failed'1m/s,
10m/s failed', 'All TxFingerp.failed'Coil Fingerp. Failed', 'CMR, Coil failed'1m/s, Coil failed', 'CMR,1m/s,Coil
failed'10m/s, Coil failed', 'CMR,10m/s,Coil faile'1, 10m/s,Coil failed', 'All Fingerp. failed'No Verific.performed'
The manual fingerprint is created on-site prior to verification of the transmitter.
Here: Display of the determined values.
.