Custom Page Creation Tutorial; Page Creation Procedure - gefran 3850T Use And Installation Manual

5.4.

Custom page creation tutorial

8
1
2
3
The tutorial below illustrates how to create the GETView
sample page shown above. This custom page allows you
to manage a single PID (PID1) loop and display an image of
the machine controlled by the controller.
The following components will be added and set in the
page:
1. Bar to graphically display the PID1 process value (PV)
percentage.
2. Bar to graphically display the PID1 setpoint value (SP)
percent.
3. Bar to graphically display the PID1 output value (OUT)
percentage.
4. Numeric display of the PID1 process value (PV).
5. Numeric display of the PID1 setpoint (SP) and its ability
to be edited.
6. PID1 HEAT control status display LEDs.
7. PID1 COOL control status display LEDs.
8. "PV" text label
9. "SP" text label
10. "OUT" text label
11. Max bar percent value text label.
12. Min bar percent value text label.
13. "PV" text label
14. "SP" text label
15. Image of the controlled machinery.
The custom page in use is indicated directly from GETView:
16. Custom page number.
80703B_MHW_2850T/3850T_02-2019_ENG
9 10 11 13 4
12 14 5
5.4.1.

Page Creation Procedure

To create the sample page, proceed as follows:
1. Calls a custom page (see page 44).
2. Activates EDIT mode (see page 92).
3. Add the various component to the page and set them
(see later paragraphs).
4. Test page operations.
5. CUSTOM PAGES
16
6
7
15
97