F-Eu16 Digital Input Configuration; F-Eu16 Digital Output Configuration - gefran 3850T Use And Installation Manual

F-MIX: identification number of the module to be con-
figured. It can be selected with the + key. In the module
group, the F-MIX modules are numbered progressively, with
the module next to the communication module assuming
number 1.
The list shows the names of the variable associated with
the output. The default name is DO_nn, where nn is a se-
quential number calculated by the first F-MIX module (first
all F-MIX modules are numbered, then F-EU16 modules).
Touching the field opens the virtual keyboard where you
can enter an identifying name as you like. The name must
be unique for the entire controller and can be up to 16 char-
acters long, chosen from a ... z, A ... Z, 0 ... 9, and _. . This
name is used in creating programs and in logical functions.
Digital outputs do not have parameters to configure.
The current status is displayed on the right, next to the
name (0 = OFF, 1 = ON).
To configure the other module inputs and outputs, tap the
key at the top of the screen.

4.15.1.6. F-EU16 digital input configuration

All module digital inputs are listed, one per line. Each input
is identified by its progressive number, which corresponds
to that shown in the module wiring diagram (see paragraph
"2.8. F-EU16 digital I/O module connection diagram" on page
29).
The list contains the names of the variable associated with
the respective input. The default name is DI_nn, where
nn is a sequential number calculated by the first F-MIX
module (first all F-MIX modules are numbered, then F-EU16
modules). Touching the field opens the virtual keyboard
where you can enter an identifying name as you like. The
name must be unique for the entire controller and can be
up to 16 characters long, chosen from a ... z, A ... Z, 0 ... 9,
and _. This name is used in creating programs and in logical
functions.
Digital inputs do not have parameters to configure.
The current status is displayed on the right, next to the
name (0 = OFF, 1 = ON).
To configure module digital outputs, touch the OUT digital
key at the top of the screen.
80703B_MHW_2850T/3850T_02-2019_ENG

4.15.1.7. F-EU16 digital output configuration

All module digital outputs are listed, one per line. Each
output is identified by its progressive number, which
corresponds to that shown in the module wiring diagram
(see paragraph "2.8. F-EU16 digital I/O module connection
diagram" on page 29).
The list shows the names of the variable associated with
the output. The default name is DO_nn, where nn is a se-
quential number calculated by the first F-MIX module (first
all F-MIX modules are numbered, then F-EU16 modules).
Touching the field opens the virtual keyboard where you
can enter an identifying name as you like. The name must
be unique for the entire controller and can be up to 16 char-
acters long, chosen from a ... z, A ... Z, 0 ... 9, and _. This
name is used in creating programs and in logical functions.
Digital inputs do not have parameters to configure.
Digital outputs do not have parameters to configure.
The current status is displayed on the right, next to the
name (0 = OFF, 1 = ON).
To configure module digital inputs, touch the IN digital key
at the top of the screen.
4. CONFIGURATION
79