Temperature Information; Information System Message; Data Time Sub-Menu - gefran 3850T Use And Installation Manual

4. CONFIGURATION
correct set.
• Present (operational) indicates whether the node is
present or not.
• Net Status displays network status. If other than 5, it
signals an error.
• Miss counter shows the errors counted since the last boot.
• IP Address displays the controller IP address.
The values are read-only.
The HOME button returns to the Information sub-menu and
BACK to the previous page.

4.14.2.9. Temperature Information

This page displays information relating to the internal tem-
perature recorded by the instrument (touch panel).
The following are displayed:
• Normal operating temperature limits (Limits).
• Read real-time temperature (Istant.).
• The maximum (Max peak) and minimum (Min peak)
values recorded for normal operating temperatures.
Touching one of the two Max peak and Min peak
buttons opens a window that also specify the date and
time when the peak temperature was detected.
The table shows the overtemperature detected by the
controller. The last registered value and the date and time it
was detected is displayed for each temperature (Range).
Touch the button to open a window that displays all
the overtemperatures recorded for that temperature range.
The HOME button returns to the Information sub-menu and
BACK to the previous page.
74

4.14.2.10. Information System Message

The page shows low-level system messages that may be
useful for diagnostics in case of malfunction.
The HOME button returns to the Information sub-menu and
BACK to the previous page.

4.14.3. DATA TIME sub-menu

The DATA TIME submenu allows you to adjust the date and
time of the controller's internal clock.
The date and time may be changed only when the NTP is
disabled and batch processes are stopped.
To adjust, touch the individual fields and enter the desired
value using the virtual keyboard that appears.
The daylight savings time / winter time button may be used
for manually switching between these two periods of the
year, only when the NTP is disabled and batch processes
have been stopped.
A string indicates NTP active or NTP disabled.
80703B_MHW_2850T/3850T_02-2019_ENG