Building Programs With Default Segments (Template); Program Composition With Templates; Configuration Procedure - gefran 3850T Use And Installation Manual

7. EXAMPLES AND APPLICATION NOTES
7.2.

Building programs with default segments (TEMPLATE)

The template is a set of default segments that can be re-
used for building various programs.
7.2.1.

Program composition with TEMPLATES

Program: XZ001
Preheating
Heating
Sterilisation
Cooling
7.2.2.

Configuration Procedure

To set a template and build derivative programs, proceed
as follows:
1. Authenticate with level 2 (OEM).
2. Open the Program configuration page (Home Page >
SETUP > SETUP MGR > Controller SETUP > page 2).
3. In the page, set "Template enable ON", to enable the
template mode.
4. Open the Prog list page (Home Page > PROGRAMS).
The "TEMPLATE" system program is displayed.
5. Set all the types of segments needed to control the
machine, which can then be used when processing
programs are created. Segment configuration in the
"TEMPLATE" program follows the standard program
rules.
6. Authenticate with level 1 (Maintenance).
7. Create a new template-based program by touching the
New prog button.
8. When you need to enter a new segment in the "Seg-
ments" section, press the |:::| button and then "new
segment". A pop-up window will displayed that lists
all the segment types in the previously configured
"TEMPLATE" program.This allows you to configure
the processing program segments based on default
segments.
106
The use of the template is particularly useful if the machine
needs to manage different processes, but where the indi-
vidual processing steps are repeatable and standard.
TEMPLATE system
program
Preheating
Heating
Maintenance
Sterilisation
Cooling
Program: X900
Preheating
Heating
Maintenance
Heating
Sterilisation
Cooling
9. In the new program you can change the properties of
individual segments (name, SP setpoint, times, etc.).
10. Create, if desired, other template-based programs,
repeating steps 7 to 9.
Warning! Template-based programs inherit all the
properties defined in the "Base" and "Functions"
sections from the "TEMPLATE" program. These
properties cannot be changed.
Program: YW234
Preheating
Heating
Cooling
80703B_MHW_2850T/3850T_02-2019_ENG