gefran 3850T Use And Installation Manual page 122

7. EXAMPLES AND APPLICATION NOTES
5. "Base" configuration page 1 opens.
As the "Unit of Time" parameter, select m:s (minutes:
seconds).
As "Start mode" parameter, select Start from SP.
6. Select "Base" configuration page 2.
Delete the variables in rows 3 and 4 from the "OUT"
and "PV" columns. This will only generate SP profiles
for 2 curves.
Configure the following parameters:
• Column "OUT", row 1 = PID_01_SP.
• Column "OUT", row 2 = PID_02_SP.
• "PV" column, row 1 = AI_01 (check that variable
AI_01 is the input of the PID1 controller).
• "PV" column, row 2 = AI_02 "PV" (make sure that
the variable AI_02 is the input of the PID2 control-
ler).
• Column "PID", row 1 = 1.
• Column "PID", row 2 = 2.
7. Select "Base" configuration page 4.
Configure the following parameters:
• Column "Level 2", row 01 = DO_05.
• Column "Level 2", row 02 = DO_06.
• Column "Level 2", row 03 = DO_07.
120
• Column "Level 2", row 04 = DO_08.
Delete parameter settings from rows 05 to 16.
8. Select Segments to set the SP profile.
9. Touch the button and add the 4 SP profile seg-
ments.
10. Edit the list of available parameters for each segment.
Use the selector
the various segments.
80703B_MHW_2850T/3850T_02-2019_ENG
in the page to display