Fuse/Relay Junction Box; Inspection - TOHATSU 200 Series Service Manual

dummyhead dummyhead
OTHER ELECTRICAL

FUSE/RELAY JUNCTION BOX

INSPECTION

BLOCK FUSE INSPECTION
Disconnect the battery negative (–) cable, then the
positive (+) cable from the battery.
Remove the engine cover.
Open the fuse/relay junction box cover [1].
Remove the two block fuse screw/washers [2] and No.1
fuse [3] from fuse/relay junction box and check for
continuity.
If there is no continuity, replace the No.1 fuse.
If there is continuity, install the No.1 fuse to fuse/relay
junction box and tighten the two screw/washers to the
specified torque.
TORQUE: 3.2 N·m (0.33 kgf·m, 2.4 lbf·ft)
Check for continuity between the
terminal of fuse/relay junction box.
If the fuse is normal but there is no continuity between
the terminals, replace the fuse/relay junction box with a
new one.
10-10
[1]
[3]
terminal and
[2]
[3]