TOHATSU 200 Series Service Manual page 139

dummyhead dummyhead
Install the under case grommet A [1] to the groove [2] of
the front cover bracket as shown.
Install the remote control cable plate [3] to the groove
[4] of the front cover bracket and tighten the bolt (6 x 16
mm) [5].
Install the following:
– Shift control cable pivot (page 20-3*)
– Throttle control cable pivot (page 20-6*)
Install the shift control cable [1] and throttle control
cable [2] by aligning their grooves [3] with the grooves
in the cable plate.
Put the remote control cables in under case grommet A
[4].
Set the grommet band [1] and tighten the screw [2].
Make sure the fuel tube A is not pinched by the under
case grommet A [3].
Adjust the following:
– Throttle operation (page 3-12*)
– Shift operation (page 20-3*)
Install the front separate cover (page 6-4*).
OTHER ELECTRICAL
[5]
[1]
[1]
[3] [1]
[3]
[4]
[2]
[2]
[4] [3]
[2]
10-5