TOHATSU 200 Series Service Manual page 153

dummyhead dummyhead
Apply engine oil to a new O-ring (59.4 x 3.1 mm) [1],
and install it to the starter motor [2].
Install the starter motor, but do not tighten the starter
motor bolts.
Tighten the bolts and nuts to the upper side of the
engine assembly in the numbered order to the specified
torque.
TORQUE:
44 N·m (4.5 kgf·m, 32 lbf·ft):
Flange bolt (10 x 55 mm) [3] (two)
Starter bolt (10 x 90 mm) [4] (one)
Starter bolt (10 x 110 mm) [5] (one)
Mount case flange nut (10 mm) [6]
75 N·m (7.6 kgf·m, 55 lbf·ft):
Flange bolts (12 x 95 mm) [7] (two)
Install the cap [8] to the bolt (10 x 55 mm) of the L. side.
ENGINE REMOVAL/INSTALLATION
[5]
1
2
[7]
7
5
[6]
[3]
[4]
[2]
[1]
[4]
4
3
[5]
[8]
8
6
[3]
13-7