Fuses; Electric Starter Will Not Operate; Battery Will Not Charge; Fuse Replacement - TOHATSU BFT 200D Owner's Manual

TAKING CARE OF UNEXPECTED PROBLEMS

FUSES

Electric Starter Will Not
Operate
The 7.5 A, 10 A, 15 A, 20 A, and
30 A main fuses protect the electric
starter relay and related circuits.
The 30 A main fuse protects the
ignition switch and related circuits. If
this fuse blows, the engine will not
start or run.
The 40 A fuse is in the power harness
connected to the battery. If this fuse
blows, the engine will not start or run.

Battery Will Not Charge

A 150 A ACG fuse protects the
alternator circuit. If the ACG fuse
blows, the engine will not charge the
battery. Refer to ACG Fuse (p. 122).
120

Fuse Replacement

Disconnect the battery cable at the
battery negative (–) terminal before
replacing the fuse.
Failure to do so may cause a short
circuit.
Main Fuse
1. Stop the engine.
2. Disconnect the battery.
3. Remove the engine cover (p. 88).
4. Open the junction box cover.
SPARE FUSES MAIN FUSES
(7.5 A, 10 A, 15 A, 30 A) (7.5 A, 10 A, 15 A, 20 A, 30 A)
JUNCTION
BOX
COVER
FUSE PULLER
SPARE
FUSE
(20 A)