TOHATSU 200 Series Service Manual page 110

dummyhead dummyhead
FUEL SYSTEM
ASSEMBLY
Install a new O-ring [1] to the insulator A [2].
Install the ring [3] to the insulator A and install them to
the fuel pump unit [4].
Install the fuel pump Assy. to the fuel pump case [5]
securely.
Install the insulator B [6] and plate [7] to the fuel pump
Assy.
Install the collar [8] and a new O-ring [9] to the fuel
pump Assy.
Install the grommet [10] and collar [11] to the fuel pump
case.
Install a new O-ring [12] to the drain screw [13] and
tighten the screw to the specified torque.
TORQUE: 1.5 N·m (0.15 kgf·m, 1.1 lbf·ft)
Install the harness holder [1] to the fuel pump cover [2].
Install the holder [3] to the fuel pump cover and set the
two terminals [4] of the harness as shown.
Install a new O-ring [1] to the fuel pump case [2].
Connect the Blue/Yellow terminal [3] of the fuel pump
cover side to the positive (+) terminal [4] of the fuel
pump side.
Connect the Black terminal [5] of the fuel pump cover
side to the negative (–) terminal [6] of the fuel pump
side.
5-54
[7]
[6]
[3]
[2]
[5]
[13]
[12]
[3]
[2]
[2] [5]
[1]
[9]
[8]
[4]
[1]
[11]
[10]
[4]
[1]
[3]
[4] [6]