TOHATSU 200 Series Service Manual page 126

dummyhead dummyhead
IGNITION SYSTEM
IGNITION SYSTEM TROUBLESHOOTING
IGNITION SYSTEM
NO SPARK(S)
1. MIL inspection
Turn the combination switch ON and check that the MIL stays ON.
Does the MIL stay ON?
YES
NO
2. Emergency stop switch clip inspection
Check the emergency stop switch clip.
Is the emergency stop switch clip connected?
YES
NO
3. Direct ignition coil inspection
Temporarily exchange the direct ignition coil with a known good direct ignition coil and perform the spark
test.
Is there spark?
Sparks– Faulty original direct ignition coil.
One plug has no spark –GO TO STEP 4.
All plugs have no sparks –GO TO STEP 5.
4. Direct ignition coil signal line open circuit inspection
Turn the combination switch OFF.
Disconnect the ECM connector A
Check for open or short circuit between the direct ignition coil 3P connector main wire harness side No.1
terminal and ECM connector A
Is the circuit normal?
YES
NO
5. Fuse inspection
Check for a blown No.5 (15 A) fuse.
Is the fuse blown?
YES
NO
6. Direct ignition coil power/ground line open circuit inspection
Turn the combination switch OFF.
Disconnect the direct ignition coil 3P connector.
Turn the combination switch ON.
Measure the voltage at the direct ignition coil 3P
connector main wire harness side No.2 (Black)
terminal and No.3 (Yellow/Black) terminal.
Does battery voltage exist?
YES
NO
8-2
– PGM-FI troubleshooting (page 5-8)
– GO TO STEP 2.
– GO TO STEP 3.
– Set the clip securely.
– GO TO STEP 6.
– Repair open or short in the main wire harness between the ECM and direct ignition coil.
– Replace the blown fuse and check for short in the main wire harness or incorrect load by referring
to the fuse load chart (page 4-4).
– GO TO STEP 6.
– GO TO STEP 7.
– Repair open in the main wire harness
between the ECM and direct ignition coil.
.
terminal of the same colors.
DIRECT IGNITION COIL 3P CONNECTOR
MAIN WIRE HARNESS SIDE
GND1
(Black)
PHC 1/2/3/4/5/6
(Yellow/Black)