TOHATSU 200 Series Service Manual page 143

dummyhead dummyhead
Remove the three bolt/washers (6 x 27 mm) [1], wire
harness clip [2] and two harness band clips [3].
Remove the two power tilt relay mounting bolt/washers
(6 x 25 mm) [1], harness band clip [2] and power tilt
relay [3].
Remove the two collars [4] and two grommets [5] from
the power tilt relay.
Remove the following parts from the power tilt relay
case [6]:
– Connector bracket mounting bolts (6 x 10 mm) [7]
(two)
– Connector brackets [8] (two)
– Collars [9] (three)
– Grommets [10] (three)
Installation is in the reverse order of removal.
• Route the wire harness properly (page 2-3).
TORQUE:
Connector bracket mounting bolt:
5.0 N·m (0.51 kgf·m, 3.7 lbf·ft)
Power tilt relay mounting bolt/washer:
5.0 N·m (0.51 kgf·m, 3.7 lbf·ft)
[9] [6]
[10]
[8]
[3]
[2]
[4]
[2]
[7]
OTHER ELECTRICAL
[1]
[3]
[3]
[1]
[5]
10-9