TOHATSU 200 Series Service Manual page 151

dummyhead dummyhead
Turn shift shaft A [1] so that the cutout [2] is positioned
as shown. (This position shows shift shaft A is in the
neutral position.)
Install shift shaft A [1], washer [2] and shift shaft B [3] by
aligning the punch mark [4] on shift shaft A with the
punch mark [5] on shift shaft B.
• Do not install the engine assembly without aligning
the punch marks. Take care not to let the punch
marks get out of alignment during the engine
installation.
• Proper shifting cannot occur unless the punch marks
are aligned.
Install the washer (14 mm) [6] into the shift shaft B.
Attach the engine chains [1] to the engine hangers [2].
• When lifting the engine assembly, take care to keep
it level.
ENGINE REMOVAL/INSTALLATION
Viewing from the lower side
[2]
of the mounting case.
Cruising direction
[1]
[1]
[4]
[5]
[2]
[6]
[2]
[3]
[1]
13-5