TOHATSU 200 Series Service Manual page 170

dummyhead dummyhead
CYLINDER BLOCK
Position the harness clamp [1] against the stopper [2] of
the cylinder block, then install and tighten the bolt (6 x
14 mm) [3].
Install the following parts:
– Flywheel (page 15-6*)
– EOP switch (High pressure side) (page 5-107*)
– EOP switch (Low pressure side) (page 5-108*)
– EBT sensor (page 5-109*)
– Knock sensor (page 5-108*)
– Oil filler extension (page 12-5*)
– Oil level gauge cover (page 12-5*)
– Neutral switch (page 9-7*)
– Shift link bracket (page 20-8*)
– Shift arm (page 20-10*)
– Alternator (page 7-5*)
– Power tilt relay case (page 10-8)
– ECM bracket (page 10-5*)
– Thermostat (page 11-5*)
– Oil filter (page 3-6*)
– Cylinder head (page 14-24*)
– Engine assembly (page 13-4)
15-14
[3] [1]
[2]