Main Axis Control; Wiring Diagram - Adtech ADT-CNC4220 User Manual

Please check whether the connection of phase Z signal is normal. In main axis encoder test interface,
press the Z key to enter the main axis encoder origin signal test method, as in the picture below
Rotate the encoder for four circles in low speed manually and the information in the picture below
appears in normal condition. If the prompt that main axis encoder origin signal is normal doesn't
appear after four circles, the phase Z signal of the encoder or the controller may be damaged. Please
change the encoder.

13.7. Main axis control

13.7.1 WIRING DIAGRAM

(Analog voltage, position, brake signal, positive/negative rotation control)
Definition of analog main axis interfaces
XS8 interface
CNC 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
Main axis encoder test
Main axis
encoder
Handheld box test
Handwheel
Main axis encoder origin signal is normal
Main axis encoder test
Main axis
encoder
Handheld box test
Handwheel
Main axis encoder origin signal test; please
rotate the encoder for four circles
(Analog main axis)
Connection of CNC4220 frequency inverter
Frequency inverter signal interface
71