Turning Off; Manual Operation; Manual Feeding; Quick Moving - Adtech ADT-CNC4220 User Manual

significantly different from the actual position when the power supply is cut off. Please align the
knife again.

2.8 Turning off

Before turning off, please make sure:
1. Axis X and axis Z of machine tool are stopped;
2. The auxiliary functions (e.g. main axis, water pump, etc.) are disabled;
3. Please cut off the machine tool power supply and then the machine tool power supply
4. When the machine tool is electrified, the position is (X +00000.000, Z +00000.000),
please perform the mechanical reset operation first.
Press the Manual
operations like manual feeding and main axis control.

3.1 Manual feeding

Press the
key to stop the axis motion. At this moment, you can adjust the manual magnification to change the
speed of manual feeding; press the
direction, and release the key to stop the axis motion. At this moment, you can adjust the manual
magnification to change the speed of manual feeding.
In manual feeding mode, press the
Note: The manual feeding can be adjusted only in position interface and manual mode.

3.2 Quick moving

Press the
positive direction quickly, release the key to stop the motion of the axis, and you can adjust the
quick magnification to change the moving speed; press the
Z in negative or positive direction quickly, release the key to stop the motion of the axis, and you
can adjust the quick magnification to change the moving speed.
During manual quick moving, press the
manual feeding speed.
Note 1: The speed, time constant, acceleration/deceleration mode during quick moving are same
to the quick moving (G00 orientation) of program instruction;
Note 2: Only one axis is valid in manual mode.

3.3 Manual magnification selection

In manual feeding and cutting, press the magnification
/
interface to decrease or increase the manual feeding magnification, which contains 16 levels
and 10% each level.

3.4 Quick magnification selection

3. Manual operation

key to enter the manual operation mode, in which you can perform
or key to feed axis X in negative or positive direction, and release the
key, and then press the
key when the quick magnification appears in the lower left corner of the position
CNC 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
or key to feed axis Z in negative or positive
key to enter manual quick moving state.
or key to move the axis X in negative or
key to disable the quick moving and move in
or key to move the axis
key, and then press the
22