Main Axis Speed Regulation; Single Section Running - Adtech ADT-CNC4220 User Manual

 Feeding magnification regulation
Press the Magnification key
magnification in 16 levels.
Press the
Press the
Note 1: the value specified by F in feeding magnification regulation program
Note 2: actual feeding speed = speed specified by F × feeding magnification
 Quick magnification regulation
During automatic running, press the magnification key
magnification regulation mode. Press the
magnification in four levels.
Press the
Press the

8.1.5 MAIN AXIS SPEED REGULATION

During automatic running, if the main axis speed is controlled by analog voltage, you can adjust
the speed of main axis.
Press the
You can adjust the main axis magnification in eight levels (50%-120%)
Press the
key once to decrease the feeding magnification by one level, until 50%
Note: the maximum output value of analog voltage = specified maximum output value of analog
voltage × main axis magnification
For example: set the system parameter 52 to 9999, execute the S9999 instruction, select 70%
for main axis magnification, and then the actual analog voltage output ≈10×70%=7V
State during running

8.1.6 SINGLE SECTION RUNNING

If it is the first time to execute the program, please selection single section to avoid accidents
by programming errors.
key once to increase the feeding magnification by one level, until 150%;
key once to decrease the feeding magnification by one level, until 0;
key once to increase the feeding magnification by one level, until 100%;
key once to decrease the feeding magnification by one level, until F0.
or key to adjust the magnification of main axis and change the speed.
key increase the feeding magnification by one level, until 120%; press the
CNC 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
and the or
key to adjust the quick
or
key to adjust the feeding
to switch to quick
44