Settings In Graph Interface; System/Diagnosis Parameters Setting - Adtech ADT-CNC4220 User Manual

10.1.2 SETTINGS IN GRAPH INTERFACE

Press the Setting
to display the graph parameter interface.
Setting method:
A. In MDI mode, press the
B. Type the corresponding value;
C. Press the

10.1.3 SYSTEM/DIAGNOSIS PARAMETERS SETTING

Through the parameter setting, you can adjust the characteristics of the drive, machine tool, etc.
Setting method:
A. Turn on the parameter switch in the method described in Chapter 1.1;
B. Select the MDI mode, press the Parameter key
the
C. Press the
D. Input new parameter value;
E. Press the
F. After setting all parameters, please turn off the parameter switch;
The setting method of diagnosis parameters is same to the setting of system parameters.
key to enter the graph interface, and then press the
/
key to complete the setting
/ key to search for the page of required parameters;
/ key to select desired parameter number
key to input and display the parameter value;
CNC 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
key to move the cursor to specified parameters;
to enter the parameter interface, press
or key
48